Info - Revised HVAC Blower Motor Installation Procedures #03-01-37 …

Short Description
1994-2002 Cadillac Eldorado. The intent of this bulletin is to provide … Body Front End sub-section of the Service Manual or SI document #369605. …

Website: acdelcotechconnect.com | Filesize: 104kb

Content
Document ID# 1405209 See also ACDelco
Bulletin 03D-J-170
Info - Revised HVAC Blower Motor
Installation Procedures #03-01-37-002 -
(11/19/2003)
Revised HVAC Blower Motor Installation Procedures
1994-1997 Cadillac Seville
1994-1999 Cadillac DeVille
1994-2002 Cadillac Eldorado
The intent of this bulletin is to provide technicians information regarding the
proper installation of the Heating, Ventilation and Air Conditioning (HVAC)
Module blower motor (with impeller) assembly.The current available HVAC Module blower motor for the above listed vehicles
can be identified by the three mounting holes (1). The original equipment blower
motor had five mounting holes.
In order to avoid confusion and ensure a high level of customer satisfaction,
when replacing an HVAC Module blower motor, refer to this bulletin for the
appropriate procedure.
DeVille-HVAC Blower Motor
Caution
Before servicing any electrical component, the ignition key must be in the OFF or
LOCK position and all electrical loads must be OFF, unless instructed otherwise
in these procedures. If a tool or equipment could easily come in contact with a
live exposed electrical terminal, also disconnect the negative battery cable.
Failure to follow these precautions may cause personal injury and/or damage to
the vehicle or its components.
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the cross-car brace. Refer to Brace Replacement-Cross Vehicle in the
Body Front End sub-section of the Service Manual or SI document #369605.
3. Disconnect and position the ignition control module assembly out of the way.
Refer to Ignition Control Module Replacement in the Engine Controls sub-section
of the Service Manual or SI…