Fuel Management System for fuel injected Kawasaki Vulcan 900. motorcycles

Short Description
Fuel Management System for fuel injected Kawasaki Vulcan 900. motorcycles. Please take the time to read … Following the factory service manual remove fuel …

Website: www.fuelpakfi.com | Filesize: 220kb

Content
5
INSTALLATION INSTRUCTIONS
KAWASAKI
TOOLS NEEDED
- #1, 3 Phillips Screwdriver
- 4 mm Allen Wrenches
- 10 & 12 mm Socket & Wrench
- Pliers
- Less than 2 hours
Kawasaki Vulcan 900
Fuel Injected Models
INTRODUCTION: Congratulations on your purchase of the Fuelpak
Fuel Management System for fuel injected Kawasaki Vulcan 900
motorcycles. Please take the time to read the entire instruction manual
before attempting to install. DO NOT adjust the Fuelpak until you have
thoroughly read the instruction manual and the unit is fully installed. If
you have questions, please call (562) 921-0071.
SUMMARY: To achieve the optimum performance from your
application, it is recommended that you install a high performance
air filter in conjunction with this unit. The Fuelpak will be installed
in-line the factory injector wiring harness and the throttle position sensor. The
Fuelpak will be tucked behind battery.
1. Remove seat. Following the factory service manual remove fuel
tank.
2. Remove 2 bolts securing battery cover then remove battery
cover. (Fig. 1)
3. Remove right side cover.
4. Route Fuelpak wire from battery area, under frame towards
throttle body. (Fig. 2)
5. Unplug stock harness from front and…