Installation Instructions for FORD FOCUS

Short Description
Installation Instructions for FORD FOCUS. Tools & Materials Needed: …. Using templates provided, place templates over manual regulator crank-hole in Door …

Website: www.a1electric.com | Filesize: 162kb

Content
Installation Instructions for FORD FOCUS
Tools & Materials Needed:
1. Utility Knife
2. Wire Crimper
3. Torx. Wrenches
4. Hex Nut Drivers
5. Drill and Bits
6. Phillips Head Screw Driver
7. Crank Spring Removal Tool
(Special Tool, available at most
Auto Parts Stores) - or -
8. Flat Screw Drivers (2)
9. Add-A-Circuit. fuse adapter
10. Silicon Sealant (Clear or Black)Procedure: (Approximate time to complete installation: 3 - 4 hours)
A. Removing the Door Panel Coverings
1. For ease of installation, do both sides at the same time.
2. Roll the windows to approximately 1/2 open, and so the crank handle is in the Down
Position. With either the Crank Spring Removal Tool, or a flat Screwdriver, remove
the spring, located in a slot on the back of the crank.
3. Remove the cover plate for the remote-control mirror, which is held in place by 3
spring clips. Remove by gently pulling the front corner of the cover out, and then slide
the cover back.
4. Remove the door Pull-handle cover, by inserting a screwdriver into the access hole on
the bottom of the handle, and using the screwdriver as a lever, pop off the handle cover.
5. Remove the button covering a retaining screw in the interior door latch backing plate.
6. Remove the 8 Torx. retaining screws around the perimeter of the door panel, and the
single Torx. retaining screw in the interior door latch.
7. Remove the 2 hex bolts in the door handle.
8. Gently lift the panel upwards, to…