2008+ Mitsubishi Lancer QuickLIFT Installation Guide

Short Description
Step 3 - Mark centerline of fender bracket location. 2008+ Mitsubishi Lancer. QuickLIFT Installation Guide. This manual is property of Redline Tuning LLC. …

Website: www.redlinetuning.com | Filesize: 283kb

Content
Please gather the following tools before you begin the installation:
* Power Drill
* 3/16″, indexed #11 & 5/16″ drill bits
* Fine permanent marker or felt tip pen
* Tape measure or ruler
* Masking tape
* Hammer & center punch
* Rivet gun, capable of 3/16″ rivets (most brands can handle this
size)
Note: Only use the rivets supplied in the QuickLIFT system.
Recommended: Craftsman standard or
Swivel Riveter (shown - 974749) - $9.99 to $17.99
Remove all items from the packing tube. You should have the following before beginning:
* (2) Gas springs (RT-QL-170-A6A) - Be sure to cycle them a few times before installing.
* (4) #2-3/16″ Multi-grip rivets (used on hood brackets)
* (2) ball-studs and washers each with a locking nut.
* (2) mounting brackets
* Printed Color Instructions
* Gas Spring locking clips - (Already installed in the gas spring ball-ends -
Remove before assembly)
A. Open and prop your hood.
B. Standing on the driver’s side in the middle of the engine compartment, examine the area on the…