Installing Symantec Backup Exec Quick Start with an Exabyte Device

Short Description
Symantec Backup Exec 11d Usage Resources. http://www.exabyte. com/support/online/kb/display.cfm?id=2046. Symantec Backup Exec 11d Troubleshooting Resources …

Website: www.tandbergdata.ru | Filesize: 254kb

Content
WWW.TANDBERGDATA.COM
Copyright 2007 Tandberg Data Corporation: Exabyte, the Exabyte Logo, EZ17, M2, VXA, and VXAtape are registered trademarks;
ExaBotics, MammothTape, and SmartClean are trademarks; SupportSuite is a service mark. Linear Tape-Open, LTO, the LTO Logo,
Ultrium and the Ultrium Logo are trademarks of HP, IBM, and Quantum in the US and other countries. All other product names are
trademarks or registered trademarks of their respective owners.
March 2007
INSTALLING SYMANTEC
BACKUP EXEC QUICK START
WITH A TANDBERG DATA DEVICE
This document provides instructions on how to quickly get started using the Symantec
Backup Exec Quick Start software with a Tandberg Data storage device. See the
Additional Information section for additional details.
STEP 1: VERIFY THE ENVIRONMENT
SERVER HARDWARE REQUIREMENTS
..Processor: Intel Pentium, Xeon, AMD, or compatible
..Disk space:
..Typical installation: 696 MB
..Recommended: 2 GB
..Memory requirements:
..Minimum: 256 MB RAM
..Recommended: 512 MB RAM (or more for better performance)
..Interface requirements:
..LVD SCSI card: Ultra160 or Ultra320 with 68 pin connector
-or-
..USB connector
-or-
.. SATA connector
..Latest driver from the HBA manufacturer
Install the latest driver available from the controller…