2000 GLF1800 Oxygen Sensor Replacement

Short Description
The purpose of this Service Bulletin is to provide information to assist you in the replacement of both oxygen (O2) sensors on affected 2001 GL1800/A models. Moisture in the exhaust can damage the O2 sensors. Also, the right O2 sensor coupler can become corroded which will result in a non-functioning sensor. A replacement kit that contains two new O2 sensors is needed to repair the problem. Only perform this procedure if the vehicle actually experiences an O2 sensor failure.

Website: www.ridersrally.com | Filesize: 136kb
No of Page(s): 2

Content
REPAIR PROCEDURE
1. Remove the top shelter (see page 2-10 in the Service Manual).
2. Remove the left and right O2 sensors from the exhaust pipes.
• You do not have to remove the exhaust pipes to remove the O2 sensors.
• Be sure to note the wire routing for proper reassembly.
3. Install the new O2 sensors and route the wires properly (see pages 1-33 and 1-34 in the 2001-Service Manual).
4. Connect the black 4P female coupler of the subharness kit to the wire harness side black 4P male coupler (for the left-side O2 sensor).
5. Connect the new left O2 sensor to the black 4P coupler on the sub-harness.
…