Honda GL1800 Trailer Hitch Installation Instructions

Short Description
THE BUSHTEC GL1800 VERTICAL RECEIVER HITCH SYSTEM HAS BEEN EXCLUSIVELY DESIGNED FOR USE ONLY ON A STOCK HONDA GL1800. IT WILL NOT WORK ON ANY OTHER MOTORCYCLE. ANY MODIFICATION TO ANY PART OF THIS HITCH, INCLUDING BUT NOT LIMITED TO ALTERING THE SUPPLIED HARDWARE OR IMPROPER INSTALLATION COULD CAUSE INJURY OR DEATH AND IMMEDIATELY VOIDS ANY AND ALL WARRANTIES.

Website: www.bushtec.com | Filesize: 70kb
No of Page(s): 9

Content
…
1. Place the motorcycle on its centerstand on level ground. Remove the four bolts in the seat handles with a 6mm Allen head socket and remove the seat. NOTE: The rubber bushings inside the seat may fall out during removal; Make sure they are in place upon reassembly.
2. Remove both side covers.
3. Remove the (5) five bolts in the rear fender (license plate panel, between saddlebags) with a 5mm Allen head socket. Remove the rear fender. NOTE: The fifth bolt is behind the license plate.
4. Remove the (3) three bolts in the passenger floorboard holder cover with a 5mm Allen head socket. Remove the cover and repeat for other side.
5. Remove the (2) bolts in the rear saddlebag guard with a 12mm socket. Remove the saddlebag guard and repeat for other side.
6. Remove the bolt in the muffler hanger using a 12mm socket. Repeat for other side.
7. Loosen, but do not remove, the muffler clamps using a 6mm Allen head socket. Rotate the mufflers down slightly to allow the hitch hoop to slide between the mufflers and the saddlebags.
…