Honda Service Bulletin, 2002 Civic 3-Door and CR-V MIL Comes On With DTC P0341
Short Description
SYMPTOM
The MIL is on, and DTC P0341 [variable valve timing control (VTC) phase gap] is set.
PROBABLE CAUSE
The VTC control solenoid valve is temporarily stuck or contaminated.
Website: www.crvownersclub.com | Filesize: 82kb
No of Page(s): 1
Content
…
REPAIR PROCEDURE
1. Use the PGM Tester to read and clear the DTC(s).
2. Start the engine, and let it idle.
3. Check the engine idle:
• If the engine does not idle smoothly, go to step 4.
• If the engine idles smoothly, go to step 5.
4. Replace the VTC control solenoid valve. Refer to page 11-127 of the 2002 Civic Si Service Manual or page 11-133 of the 2002 CR-V Service Manual.
5. Make sure you have the Interactive Network (iN) CD (July ‘02 or later) loaded into your iN master terminal. If not, load the CD using the instructions that come with it.
6. Update the ECM/PCM software with the Honda Interface Module (HIM). Refer to S/B 01-023, Using the Honda Interface Module to Update Control Units/Modules.
…
Get the file Download here
Related Searches: variable valve timing, pcm software, variable valve timing control, honda service, master terminal
Comments
Leave a Reply
