Cisco 700 Series Router Cabling and Setup Quick Start Guide
Short Description
This document describes the basic process of cabling and configuring the Internet access device, the Cisco 700 series router. For advanced cabling information, refer to the Cisco 700 Series Router Installation Guide. For advanced configuration information, refer to the Cisco 700 Series Router Command Reference and the Cisco 700 Series Router Software Configuration Guide. These documents can be found on the Cisco Documentation CD-ROM and Cisco Connection Online (CCO).
Website: www.cisco.com | Filesize: 359kb
No of Page(s): 8
Content
…
Verify the PC Setup
Before you begin, verify that each computer that will be connected to the computer has a network interface card (NIC) installed and TCP/IP loaded.
Connect a 760 Series Router to a PC or Hub
Step 1 If you are connecting the router to a computer, connect the yellow Ethernet cable from the yellow Ethernet port on the rear panel of the router to the Ethernet port on the network interface card on the computer.
If you are connecting the router to a hub, connect the yellow Ethernet cable from the yellow Ethernet port on the rear panel of the router to an Ethernet port on the hub.
Step 2 If you are connecting the router to a computer, to a hub, set the node-hub switch to the “NODE” position and connect the computers to the hub as described in the documentation provided with your hub.
…
Get the file Download here
Related Searches: software configuration guide, network interface card, cisco 700, node hub, series router
Comments
Leave a Reply
