Running Light Conversion Brake Override 4-Way Emergency Flash Installation Guide

Short Description
signalMinder is a 100% solid-state device, which replaces the existing turn signal relay of your bike - in many cases this a simple plug-in procedure. But depending on your bike, you may need additional hook-up.

Website: www.kisantech.com | Filesize: 1715kb
No of Page(s): 38

Content
…
1. Locate the original turn signal flasher and replace it with appropriate signalMinder - attach ground wire if needed. The basic step will provide cancellation with 3 selectable timeouts. However, to utilize the built-in features of the signalMinder, following steps are needed.
2. Locate right and left signal wires and brake wire of the bike and tap into them with Scotchlock T-Tap connectors supplied. This step will enable:
- Running Lights - front and rear.
- 4-Way emergency flash and Escort mode flash.
- Brake override and Brake flash feature.
Finally, for the bikes with a SINGLE handlebar switch requiring Push-to-Cancel to bring the switch back to neutral, next step is needed.
3. Remove the turn signal switch from the handle bar and install either metal springs or foam plugs so that it returns to neutral. This step of modifying the handlebar switch transforms the bike to a fully automatic turn signal cancellation system.
…