Canon Macro Ring Lite ML-3 Flash instructions

Short Description
Exclusively designed for the EOS cameras and T90 with macro lenses, the Canon Macro Ring Lite ML-3 is a high performance, automatic electronic flash unit for close-up shooting.
The Macro Ring Lite ML-3 adopts TTL (through-the-lens) control system, considered the most effective method for close-up shooting, which frees you from the troublesome exposure compensations or complex calculations of close-up flash photography. Flash tubes are on the right and left sides, and can be fired together or seperately for extra lighting versability.

Website: www.canonfd.com | Filesize: 1052kb
No of Page(s): 19

Content
…
Use tour, new, size-AA alkaline-manganese (LR6) or Ni-Cd batteries. Carbon-zinc batteries may also be used, but their life is shorter. Wipe the battery terminals with a dray, clean cloth to ensure proper contact.
1) Slide the battery chamber cover in the direction of the arrow and lift off.
2) Load the batteries so that their terminals face in the directions indicated by the diagram inside the battery chamber.
3) Once the batteries are loaded, slide the battery chamber cover back on while pressing the batteries down. Make srue that the cover’s tabs fit into the corresponding grooves on the control unit.
Note:
- When the batteries become exhausted, replace all four at the same time with the same brand.
- Battery performance deteriorates in cold temperatures below 0 C/32 F so please keep the batteries warm until just before use. For best results, use fully-charged Ni-Cd batteries in especially cold temperatures. When using Ni-Cd batteries, please note that various brands have different terminals. Be sure to use a suitable type. Recharge Ni-Cd batteries according to the manufacturer’s instructions.
- Remove the batteries if you do not expect to use the flash for three weeks or longer.
…