LUBRICATION OIL AND OIL FILTER REPLACEMENT (Toyota 2008 Highlander)
Short Description
CAUTION:
- Prolonged and repeated contact with engine oil will result in the removal of natural oils from the skin, leading to dryness, irritation and dermatitis. In addition, used engine oil contains potentially harmful contaminants which may cause skin cancer.
- Precautions should be taken when replacing engine oil to minimize the risk of your skin making contact with used engine oil. Protective clothing and gloves that cannot be penetrated by oil should be worn. The skin should be washed with soap and water, or waterless hand cleaner, to remove any used engine oil thoroughly. Do not use gasoline, thinners, or solvents.
- In order to preserve the environment, used oil and used oil filters must be disposed of at designated disposal sites.
Website: sumbiz03.home.comcast.net | Filesize: 129kb
No of Page(s): 5
Read more
Toyota – Reset Engine Oil Replacement Reminder Light
Short Description
09 Avalon
After changing the engine oil (U.S.A. only)
The oil change system should be reset. Perform the following procedures:
1. Switch the display to the odometer. (Page 142)
2. Turn the “ENGINE START STOP” switch or the engine switch OFF.
3. Vehicles with smart key system: While pressing the trip meter reset button, turn the “ENGINE START STOP’ switch to IGNITION ON mode. Continue to press and hold the button until the trip meter displays 000000.
Vehicles without smart key system: While pressing the trip meter reset button, turn the engine switch to the “ON” position. Continue to press and hold the button until the trip meter displays 000000.
Website: www.beavertontoyota.com | Filesize: 95kb
No of Page(s): 6
Read more
Toyota Service Bulletin – Shock Absorber Replacement Criteria
Short Description
The purpose of this TSB is to provide a quick reference to assist in making easy judgements regarding shock absorber and strut replacements.
Website: priuschat.com | Filesize: 124kb
No of Page(s): 4
Read more
Toyota – Oil Filter Cap Assembly Precautions
Short Description
The information contained in this TSB supersedes TSB No. T-SB-0332-08.
• Applicability has been updated to include 2009 – 2010 model year Highlander, 2010 model year Camry, Corolla, Matrix, Sequoia, Tundra, and 2009 model year Venza vehicles.
• The SST table has been updated with an illustration.
• The Notice in the Repair Procedure has been updated with a Figure and torque specification ranges to clarify SST usage.
TSB No. T-SB-0332-08 is Obsolete and any printed versions should be discarded. Be sure to review the entire content of this service bulletin before proceeding.
Website: www.toyotapart.com | Filesize: 208kb
No of Page(s): 4
Read more
Toyota Technical Service – BRAKE ACTUATOR NOISE 04-07 Prius
Short Description
Some 2004–2007 model year Prius vehicles may exhibit a squeak–type noise when pressing or releasing the brake pedal. This noise may only be audible when the vehicle is in “READY” mode and the vehicle is not moving. Brake system performance is not affected by this noise. Use the following procedure to address this concern.
Website: priuschat.com | Filesize: 35kb
No of Page(s): 2
Read more
TOYOTA TUNDRA 2007- BIG BRAKE KIT Installation
Short Description
If the OE wheels are not used, then see the brake caliper template available from your dealer via Toyota’s TIS system or TRD.com. The brake caliper template must be used to insure there is adequate clearance between new brake components and non-OE wheels and balancing weights.
Website: www.tundraheadquarters.com | Filesize: 548kb
No of Page(s): 10
Read more
Excerpts From 1990 Toyota Celica Repair Manual
Short Description
This manual contains maintenance and repair procedures for the 1990 CELICA. Applicable modles: AT180 series, ST184 series. The manual is divided into 21 sections and 4 appendixes with a thumb index for each section at the edge of the pages.
Website: www.ntsb.gov | Filesize: 377kb
No of Page(s): 9
Read more
